Reboot
Collapsible content
Step 1: Remove PCB
If your Corne v4.1 is not recognized, unscrew the bottom case and carefully remove the PCB. On the bottom, locate the BOOT and RESET buttons.
Step 2: Enter Bootloader Mode
1. Make sure the trrs cable is plugged into both halves, plug the USB into your KEYBOARD ONLY.
2. While holding the BOOT button(right side button), plug the usb into your computer
3. release BOOT button after couple seconds
Step 3: UUID Drive
Your computer should now detect a new UUID drive
- the drive will look similar to plugging in an SD card into your computer
- open the UUID Drive
Step 4: .uf2 File
- click on this link: click here
- download the first file under (standard (3x6) v4.1.0
Step 5: Drag and Drop
drag and drop the .UF2 firmware file into the UUID Drive.
Your Keyboard should now be recognized by VIA.
Step 6: Change Keymaps
1. You will also need to download the keymaps file to make changes to your keybinds click here
2. On the right side of the screen you will see multiple icons. hover over these icons and click "download raw file"
3. You can navigate to the load tab in VIA(You need to enable Design tab at the config page) and drag & drop the json file.
If you face any issues or have questions, feel free to send a message in the chat!